Four Reasons For The Poor Finished Product Of The Wool Planting Machine

First: simple bending of copper wire
1. The copper cutting part of the hair planting machine head is worn and replaced. 2. Copper cutting knife wear replacement. 3. The hair head and copper cutting knife are not properly adjusted, and they should be adjusted from the beginning. 4. If there is a foreign object on the contact surface between the hair head and the hair head center, remove it and remove it. 5. The height of the cutting knife is not properly adjusted, and it is adjusted from the beginning; Adjust the copper wire too long, shorten the copper wire. 6. Poor quality of copper wire, such as bent, too wide or too thick, replace new copper wire.
Second: the size of the copper wire of the wool planting machine, the length of the copper wire after cutting is different. 1. The copper wire clamp is worn and smoothed from the head or replaced. 2. The copper wire check is worn, and the copper wire check is used or replaced.
Third: The viewpoint of the copper wire entering the brush handle is not correct during hair planting, resulting in the copper wire being unable to jam the bristles or the copper wire simply falling off. 1. Copper wire size sheet, refer to copper wire size sheet. 2. The copper wire adjustment is too short. 3. The distance between the hair head and the brush handle is too large when planting hair, adjust the interval between the front and back. 4. The front end of the hair grafting needle is worn, smoothed or replaced. 5. The outlet piece at the front end of the hair planting head is worn and the hair transplant head is replaced.
Fourth: the bristles of the hair planting machine are not pulling enough. 1. The copper wire is too short and long. 2. If the depth of hair grafting is not good, adjust the hair grafting needle to length. The length of the bristles is uneven (all), the upper and lower positions of the brush holes are not adjusted properly, and the brush handle is adjusted from the head. Up and down, the height of the azimuth bristles is not adjusted properly, and the height of the wool rack and the hair brace is adjusted.