Wool Grafting Machine Processing Operation Mode

It is the continuous processing of products without interruption. Unless the "Stop" button is pressed, the cycle processing of the product can only be completed by placing more than 2 fixtures. Fully automated processing increases production capacity. When the product on the first fixture is processed, and the product on the next fixture is processed, the product on the first fixture can be exchanged. When the product on the next fixture is processed, the product on the previous fixture can be swapped to complete the reciprocating processing. It is assumed that only one fixture can be placed in the semi-automatic machining form. In the standby state, press the panel number key "1" to enter the full automatic operation mode. When maintenance occurs, the entire mechanical action stops. After repairing, move the machine head to a high position, use the "Step" key to find the vacant position, and then press the "Prepare" key for processing. Otherwise, in the original machined hole position, pressing the pre-processing key will cause heavy hole phenomenon, which may damage the needle. Pay attention when operating, pay attention when semi-automatic processing.
Press the "Preliminary" key to process one at a time. After processing the product, the machine head stops at a high position and works to the starting point. When changing the product, press the "Prepare" button again, work to the first hole position, and rework. It is also possible to preliminarily machine from the nth hole to the actual hole. N can be set. After entering the hole number through the keyboard, press the upper hole key and the lower hole key to work on the hole. Before pressing the "Prepare" key, make sure that the well position has not been processed. Failure to do so will damage the needle. The treatment method for maintenance is the same as for fully automatic processing.
After setting the product data, press the "upper hole" or "lower hole" button in the automatic machine test screen to complete the one-step hole alignment. You can find out if the hole is in the wrong direction. If you make an error, you can exit and enter the experience modification interface to stop modifying. When the preset is pressed, the workbench moves continuously until a product program file is completed and the work is stopped to check that the workbench is working properly.